|
|
||||||
|
 |
|||||||
| Power System: | Voltage: 85 - 260 Va.c Frequency: 48 - 62 Hz Current: > 0.25 A Fuse: 2 x T250mA 20 x 5 mm |
|
|||||
| Display: | Bargraph | Numeric | |||||
| 100 bar LED | 3½ Digit LED | ||||||
| Resolution: | 2% of range | 0.1µm / 1µm | |||||
| Accuracy: | ±1Bar or 1% of analogue signal | >0.05% reading ±1 count | |||||
| Measurement: | Single or Differential | ||||||
| Ranges (µm): | ±5.0 ±15.0 ±50.0 ±150.0 ±500 ±1500 |
||||||
| Range Selection: | 6 way rotary switch on front panel. | ||||||
| Zero Adjustment: | Channel: > ±125µm by front panel 10 turn control |
||||||
| Calibration: | Each input can be individually calibrated by recessed control at rear Range: +/-10% of nominal. |
||||||
| Connectors: | Probe: 2 x 5 pin 240º DIN screw retained. Data: 9 pin ‘D’ socket SK1: 15 pin ‘D’ socket Mains: Switched / Fused IEC power inlet. |
 |
|||||
| Probe Inputs: | 2 input channels A, B. Impedance: 10KΩ +/-2%. Sensitivity: 50mV / V /mm. |
||||||
| Probe Mix: | 3 position slide switch on rear panel or any multiple by resistor via SK1 | ||||||
| Probe Drive: | Voltage: 1.2V rms, nominal Frequency: 5.0KHz (no load) Current: 25mA |
||||||
| Tolerance Display: | By LED indication: O/S (amber), SIZE (green), U/S (red). Setting Range: Any point on scale (no crossover) |
||||||
| Outputs: | RS232: via 9 way D socket Probe signals: via SK1 Analogue: via SK1 Tolerance: via SK1 1 TTL standard load DC power: +/- 5V at 10mA |
||||||
| Environmental: | Storage: -10°C to +70°C Working: 0°C to +40°C Humidity: 10 - 95% non-condensing |
||||||
| Mechanical: | Enclosure: 2mm Mild Steel Painted Size: 384 h x 130 d x 44 w Weight: 2.85 Kg |
||||||
| Electromagnetic: Conformity |
EN61326:1998 Class A EN61010-1:2001 |
Back to VC2000 | |||||
|
